|
 
Propylex
Pumpstations
- Unique &
comprehensive range of options from sump only to complete
“package” systems.
- Sumps manufactured
from elite fabrication grade “Propylex” to provide
robust and corrosion free chambers with indefinite design life.
- Quick &
simple installation.
- Complete
range of pumps & ancillary equipment.
- Design &
Build for non standard applications.
- Comprehensive
service & maintenance contracts.
 Camtech
Pumpsystems are a uniquely versatile range of products designed
and manufactured to suit specific site applications from simple
domestic floor box units to complete “package” systems
for major industrial / commercial developments, for both sewage
and surface water.
Pumpchambers are manufactured from elite fabrication grade polypropylene
using a patented process which not only ensures the unit is extremely
robust and completely corrosion free, but also provides considerable
structural integrity, thereby allowing chambers to be installed
in most ground conditions with just a lean mix concrete back fill.
Chamber diameters are available from 450mm up to 4.0m with single
structure overall depths of up to 14.0m. Also available are purpose
built pumpsystems for internal and above ground use which will be
designed and built to meet the specific needs of any application
while remaining process efficient and cost effective. A comprehensive
range of pumps and ancillary equipment is also held in stock, from
the smallest effluent pump to solids handling and macerator sewage
pumps and high volume surface water pumps.
 Technical
Specifications
Camtech
Tank Construction
CAMTECH pump
chambers and treatment plants are manufactured from Elite Fabrication
Grade Proplyex, to the requirements of an ISO 9001 Design and Build
Quality management system, the pump chambers are available in a
range of diameters from 450mm I/D to 4000mm I/D with treatment plants
available up to 14.0m overall length.
Standards
and Approvals
No UK standard
exists for chambers manufactured in Propylex although the following
national and international standards are complied with : Elite Fabrication
Grade Propylex is an approved product manufactured in accordance
with BS476 Part 7
|
MATERIAL
PROPERTIES
|
| Density |
0.91
g/cm3 |
Tested
to ISO 1183 |
| Hardness
Shore D |
60
POINTS |
Tested
to ISO 868 |
| Skin
Thickness |
6mm
up to 1000 dia- 9mm to 1800 dia- 12mm/2000+ |
| IZOD
Impact Strength |
60
KJ/M2 @ 23ºC |
Tested
to ISO 180 |
| Flexural
modulus |
1050
Mpa |
Tested
to ISO 176 |
| Tensile
Strength Yield 2 |
6
Mpa |
Tested
to R527 |
| Tensile
Modulus |
900-1100
Mpa |
Tested
to ISO 527 |
| Vicat
Softening Point (9.8n) |
151ºC |
Tested
to ISO 306/A |
| Weather
Resistance |
No
deterioration due to UV radiation and normal ageing |
 Joining
Extrusion Welding 450mm - 4000mm diameter
Testing Standard prEN (WI 087 ). prEN 1277 : 1995
Installation
In most ground conditions CAMTECH chambers can be installed on a
concrete base with either a lean mix or granular backfill. In vehicular
areas a suitable reinforced cover slab should be provided and bear
on undisturbed ground around the excavation. If a high water table
is present CAMTECH must be informed so that we can include an anti-flotation
flange on the chamber. In these circumstances a suitable concrete
backfill will be required.
|
